Tokyo Marui USP Compact Gas Blowback

Thank you for viewing.

This is a set including the Tokyo Marui USP Compact (gas blowback), 4 magazines, and other accessories.

★ Included Accessories
PDI Inner Barrel (original also included)
LayLax Hammer Spring (original also included)
Tokyo Marui Micro Pro Sight
DCI Dot Sight Mount
TrustFire Light (GM23-2022)
Flat Magazine Bumpers (4 pieces)
(2 batteries for the Micro Pro Sight are included as a bonus.)

⚫︎ The slide of the body was replaced with a new one a few months ago.

⚫︎ The outer box is included. Please check the photos for accessories. The styrofoam inside the lid is cracked.

⚫︎ The Micro Pro Sight comes with a wrench, a small screwdriver, and a cleaning cloth, but no outer box.
It will be shipped mounted on the body.

⚫︎ The dot sight mount is of the type that is attached by removing the rear sight. The removed rear sight will be placed in the bag for the DCI mount.

⚫︎ The under rail of the body has been slightly shrunk with heat to directly attach the light.
This position makes it easier to operate the light.
The included under-mount rail can still be attached, so there should be no issues with use. Please check the photos.

⚫︎ The lens of the light has melted.
The 800-lumen light is very strong, and when I applied tape to try to slightly reduce the brightness, it melted.
It still functions as a light.
It is so bright that you cannot look directly at it.
The light will be removed from the body and shipped in a box. This is to prevent it from accidentally turning on during transport.

⚫︎ A small piece is chipped off the part behind the hammer.
It does not seem to cause any problems when shooting.

⚫︎ Two of the four magazines had gas leaks, so the gaskets were replaced. They were kept in a ziplock bag for about 3 weeks, and the bag did not inflate, so I believe the leaks have been fixed. (This is a DIY job, not professional quality.)
The magazines will be shipped with masking tape labels.

⚫︎ The PDI inner barrel may be slightly thinner, causing some play, so the gap with the chamber has been filled with aluminum tape.
The hop-up pressure rubber is a cut 50° gasket.

⚫︎ The original hop-up gasket is installed.

Please consider this item as a used product.
Thank you.